DSX Access System, Inc. WinDSX Guide de l'utilisateur télécharger pdf (Page 69)

DataBase

Time Zones

3. Set the state of this Time Zone using the Time Zone Is On/Off when Linked to

selection.

Linking to a Time Zone can force it to a pre-selected state of on or off as selected in the time

zone definition. Anything this Time Zone is assigned to is subsequently affected. This could

be used to control Access Levels, Alarm Echo, Devices (readers/keypads), Event Filters,

Image Recall, Inputs, Outputs, and Linking Groups.

Note/// When linking to a Time Zone especially with a Latch or Toggle response make sure

you have another link to it with a time zone response otherwise it may be impossible to get

that Time Zone to follow its schedule instead of its forced state. Including a Time Zone in a

Linking Group requires WinDSX© Version 3.7 and higher with controller firmware of 3114

and higher.

Do Not program a link to a Time Zone unless all field controllers have firmware version 3114

or higher! If you do you will have to delete the Linking Group from the database.

4. Determine if you want to Add this Time

Zone to All Locations in the Location Group.

Add To Location Group causes the Time

Zone to be saved into all Locations with the

same Location Group Name.

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 115 116

Pas de commentaire

DSX Access System, Inc. WinDSX Guide de l'utilisateur Page 69